![]() ![]() To reassemble your iPhone 4S, you can either follow all these directions in exact reverse order or view our reassembly video guide above which will walk you through how to reassemble it from screen to turning it back on and testing it. Use a bit of double sided adhesive if you need to. The camera hold and speaker mesh are the same and can easily be transferred as well. The Home button is only held on with a rubber gasket with a bit of adhesive. If the assembly you ordered did not come with a Home button, camera hold, or speaker assembly already attached, you'll need to remove those pieces and place them onto the new assembly. Transfer the Home button, speaker mesh, & camera hold to the new digitizer & LCD assembly Once all the adhesive is broken, carefully pull the front assembly off the iPhone taking care to make sure the digitizer and LCD cables don't get caught up in the frame.After the top of the assembly is free, move towards the bottom on either side of the Home button and repeat the same process.Once the top left is free, move over to the top right corner and repeat. ![]() Hold the iPhone so the screen is facing you and insert your pry tool or metal spatula into the top left corner and slowly start breaking the adhesive underneath the display by moving your tool gently back and forth.Remove the digitizer and LCD assemblyįor this section, we highly recommend watching the teardown video above as it will show you the technique for removing the display that will best compliment the written steps much better than pictures can. Just make sure you are careful not to bend it. Use your pry tool or metal spatula tool in order to loosen the adhesive and remove the vibrator assembly. The vibrator assembly is only held down with a bit of adhesive. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |